Capello CR2W Guia do Utilizador descarregar pdf (Página 18)

adding a new alert

The New Alerts function can be used to customize currently undened future events that would otherwise display only as

??A=Unrecognized Watch, ??E = Unrecognized Emergency, ??S = Unrecognized Statement, or ??W = Unrecognized Warning.

If a new event becomes dened or anticipated, you can program it by doing the following:



Press button until “TIME” is displayed.



Press or arrow until “NEW ALERT” is displayed.



Press to display “EVENT 1” and then arrow to choose programmable event numbers 1-5.



Press then “---” is displayed and the rst character space will start blinking. (These three characters are the event

code. Pre-dened codes cannot be saved as new alerts. See Selectable Alert Reference Chart section for a list of

pre-dened 3 letter event codes).



Use the arrow to program the rst character (A-Z, then 0-9) then arrow to move to second and third characters.



Press .



If the code was a pre-dened code the words “THE EVENT ALREADY EXISTS” will be displayed for a short time and then

“---” is displayed again. If this happens check the event code and return to step 5.



After successfully saving an event code “-- -- -- -- -- -- -- --“ is displayed and the rst character space will start blinking

for programming a user dened event description up to 11 characters in length. Use the method of step (5) to program all

11 characters. For example: “TSA THREAT.”



Press and “ADVISORY” will start blinking. Use arrow change the event level from “ADVISORY” to “WARNING,”

or “ALERT.”



Press to save your selections.



Press button twice to exit.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Sem comentários

Capello CR2W Guia do Utilizador Página 18